No child self-adhesive polymer modified bitumen membrane I. Introduction and Product Caption 1 Introduction No child self-adhesive polymer modified bitumen membrane is self-adhesive rubber asphalt, PE film, aluminum foil AL and isolation more kinds of films and other materials, without surface covering material (double-sided adhesive construction safer and more reliable), the bottom surface of the upper and lower surfaces should be covered or coated with silicon isolation release material, self-adhesive rubber asphalt recipe inside and outside class, a number of physical indicators set similar products in the industry. Requirements applicable to a variety of water projects. Double-sided self-adhesive membrane can also be used simultaneously with a variety of composite materials, the multi-channel waterproofing system (performance standards: GB / T23441-2009). 2. Product caption Second, the product features a stable high temperature performance. 2, super membrane and membrane performance bond to ensure robust and reliable lap tight, flawless. 3, the unique features of a variety of "self-healing" function. 4, super primary bonding capacity, may be due to the material damage caused by the leakage limit as much as possible in the local area, to prevent the overall failure of the waterproof layer. 5, excellent elongation properties, can adapt to smaller grassroots deformation or cracking damage. 6, safety and environmental protection, the construction process without adding solvent and fuel, to avoid the emergence of environmental pollution and fire hazards and other unsafe practices and conserve resources. Third, the scope 1, no fetal self-adhesive polymer modified bitumen membrane base for a variety of industrial and civil construction of underground works (basements, subways, tunnels) and pools, canals and other water projects covert existence, but also for in the non-exposed construction of roofing, the more applicable to the construction site not use solvents and fire works. Fourth, the construction method, the primary treatment: the base surface should be smooth, no bump, dust, oil, polymer cement mortar cracks apply some smoothing. 2. Tu primary treatment agent: grassroots brush surrounding nodes, such as brushing the corner, and then by brush or spray, spraying should be uniform. 3, the horizontal tiling: first pop up a precise reference line on the base, and then slowly paving from low to high. Expand the web at the same time, reveal the release paper, paving along the baseline, coil lap width should be greater than or equal (≥) 50mm (full stick), then ≥60mm (empty shop, point sticky, sticky strips), paving thick more should be compacted with a rubber membrane. 4, vertical Stones: Stones from the vertical to the high-low, while the isolation of paper thrown off the edge to start. Lap width above. 5 ,. shut treatment: use sealants seal shut out, and then fixed with metal beads. Fifth, the construction plans