Polymer composite self-adhesive waterproofing membrane "a", product introduction and product images Overview 1 Introduction polymer composite self-adhesive waterproofing membrane is the core material of a thin polymer material, coatings and polymer modified bitumen stick nonwoven fabric reinforced waterproofing membrane surface of the core material of the composite material. There is a great product expansion, permeability and good corrosion resistance and good flexibility, flexible construction, cold construction, environmental pollution, increase self-adhesive layer, waterproof layer bonded to form a dense concrete waterproofing closed. It can "self-adhesive wet-laid" and "pre-shop anti-stick" construction method, wet work, at the same time and place and concrete construction operations, shorten the construction period. 2, product images Overview Second, product characteristics: 1, to extend large permeable elements, corrosion. 2, good height, temperature performance, the product has a permanent waterproof. 3, waterproof layer waterproof seal concrete curing adhesive layer between the adhesive layer is formed after the increase. 4, film, flexible, flexible construction operations. 5, cold construction, environmental pollution. 6, the product may damp can be synchronized, site concrete construction operations, shorten the construction period. Third, the construction environment environmental requirements 1, the base should be dry and clean, it does not work in the rain or snow day. 2. Do not work in high winds (over 5) 3, not suitable for the construction below 0 ° C 4, if rain or snow in the course of construction, the protection of measuring the film is a must Fourth, note: 1, polymer composite waterproofing membrane on a rigid mandrel coil packaging, outer plastic packed full of columns. 2. Storage: flat storage stack height does not exceed 5 layers, prohibiting contact with acid, alkali, oils and organic solvents. Stored at a temperature not higher than 40 ℃, storage period not exceeding one year. 3. Transportation: horizontal lying, height does not exceed five prevent tipping or horizontal pressure to prevent the sun and rain 4, the film should be stored in dry and ventilated. 5, different types of films must reactor separately. 6, under normal conditions, storage for one year the production date. 7. During transport, the film roll should be vertical. It should stay away from sun and rain. Fifth, self-adhesive waterproofing membrane polymer composite construction method 1, Pre-shop method: basic self-adhesive waterproof membrane directly facing the empty shop, before pouring the concrete, insulation materials. 2, wet-laid process: the construction method of grout paste self-adhesive film. 3, taken: Paste method. And polymer cement waterproof glue material, lap width of not less than 900 mm. 4, basic treatment: surface of the base must be clean, solid, level, dry, courage, Rift Valley and lose dust. Large recess, fill it with cement mortar and then level. Remove and clean dust.If highlight substrate or profile, reduce water should do. 5, within the scope of gypsum cement grout film where paved. (Wiping cement grouting time is not recommended in a large area, the best along the membrane gypsum cement grout is spread). The thickness of the grout according to the decision smooth substrate, 3-5mm. 6, relaese paper, laying into the fresh cement grout. 7, joining side ring (overlapping) by following the film (minimum width of 60 mm) when the film installation, you can not move or walk after realized the strongest and overall adhesion for about 48 hours (depending on the cement become cured, the exact time weather ) Sixth, the production base